Made of 3/4 and 1/2 inch 6061 T6 alloy aluminum extrusions and fastened with stainless steel fasteners. Ideal for fresh or salt water use. No welds or castings to break.
The dependable, self contained and water proof hydraulic actuator has a lifting capacity of 3563 kg of thrust. More than any other transom jack. You will have no problem lifting even a V-6 motor at full throttle. The hydraulic actuator is mounted inside the structure of the Power-Lift, yet it is fully accessible without removing the engine.
The hydraulic actuator is completely self-contained with its own fluid reservoir (eliminates the need for hydraulic tank and hoses inside the boat). It contains a permanent magnet motor for more power and R.P.M.. The cylinder within the actuator has twice the lifting capacity than other transom jacks on the market. It contains a no-leak seal and wiper seal that keeps dirt and water out of the working parts. The system is made of 100% non-ferrous material which makes it impervious to saltwater and freshwater.
The patented roller design means less friction, longer wear, less maintenance, and virtually no binding problems which are common with 
other transom jacks.
The roller assembly contains a stainless steel 3/4" pin with aluminum-bronze alloy rollers.
The roller is highly impact resistant, corrosive resistant, and has a high load carrying capacity.
This patented design virtually eliminates any chance of binding which is common with other transom jacks.
Most importantly, the outboard plates on our units are fully supported throughout the vertical travel of the unit.
Have a look at other manufacturers units that are offered on the market, and you will soon see how stressed they could become when a 300HP outboard is being hammered through rough water.
Over 120 Jack Plate units sold by us in Australia over the last few years, and no problems.
The PL-65 is rated for V-6 motors and smaller and gives you 5" of vertical travel with 1-1/2" of adjustment on the motor bracket and 1-1/2" of adjustment on the transom bracket.
A TOTAL OF 8" OF POSSIBLE ADJUSTMENT! It also can be purchased with stainless steel motor rails, Model PL-65SS (for V-8 motors).
