For use with a full alloy Jacking Plate.

This kit will help reduce movement between the transom and motor plates by providing  more support for the plates to slide against.

 

$88.00 inc gst per set

or

$150.00 inc gst per set, supplied and fitted at time of purchase

These 2 degree wedges are designed to give extra positive or negative trim. 

The wedges are used as an aid for boats with an insufficient transom angle or use them as set back spacers, by simply inverting 2, 4, and 6 sets.

Hole design fits the same pattern as the Power-Lift transom bracket and standard motoring mounting.

$103.91 per pair

___________________________________________________________________________________________

____________________________________________________________________________________________

Some motors are too big for the small plate, but they need an adapter to fit on the larger plate, these are the adapter plates.

Used with the PT-130 for installation of motors mounted with transom clamps.

This adapter kit is made for quick and easy installation of these type motors.

____________________________________________________________________________________________

The transom on some pontoon boats are inset with an aluminum lip along the sides.To conveniently mount the PT-130 to this type transom, this transom spacer is available.

The transom spacers are 1 inch thick allowing you to mount the PT-130 without interference with the 1/2” to 3/4” lip around the transom on some pontoon boats.

____________________________________________________________________________________________

This weatherproof trim button switch is made of molded black plastic with raised white letters.

Attach it to your steering wheel, close to your thumb, and it will be easy to raise and lower your CMC unit on the go.

It can easily be wired to the PT-130 Power Tilt and Trim or Power-Lift wire assemblies.

$24.00

____________________________________________________________________________________________

Made of strong 3/8" 6061 T6 alloy aluminum (not cast aluminum).

The CMC transom washer can eliminate bolts “biting” into transoms and can more evenly distribute loads on high performance engines.

Hole centers:

Top Plate – 12 7/8" Bottom Plate – 9 7/8"

order only

____________________________________________________________________________________________